JEFF ROWLAND CAPRI S2 Operational Manual page 18

BAL L:
(8) This button will shift the output of the preampli er towards the left channel. Each
press of the button will increase the output of left channel by 0.5 dB and decrease the level
of the right channel by 0.5 dB. A total shift of 6 dB is possible. The balance control is not
continuous; holding the button down will not continue to shift the balance. The button
must be repeatedly pressed to continue to activate the balance shift towards the left
channel.
(9) BAL R:
This button will shift the output of the preampli er towards the right channel. Each
press of the button will increase the output of right channel by 0.5 dB and decrease the
level of the left channel by 0.5 dB. A total shift of 6 dB is possible. The balance control is not
continuous; holding the button down will not continue to shift the balance. The button
must be repeatedly pressed to continue to activate the balance shift towards the right
channel.
BATTERY REPLACEMENT:
likely necessary to replace the battery. Access to the battery is gained by removing the back
cover of the remote transmitter unit. The old batteries can be removed from the snap-on
battery terminals and new batteries reinstalled. A standard alkaline battery is recommended.
NOTE: WHEN REMOVING THE OLD BATTERY, WAIT AT LEAST 30 MINUTES BEFORE INSTALLING A
NEW BATTERY TO ALLOW THE INTERNAL CIRCUITRY TO DISCHARGE COMPLETELY AND RESET.
When the remote begins to become weak or will not function, it is
REVA1.4

CAPRI S2 PREAMPLIFIER

PAGE 17