JEFF ROWLAND CAPRI S2 Operational Manual page 15

(1) UNBALANCED INPUTS:
components (CD player, tuner, etc.), they should be connected to unbalanced INPUTS 1 and
If you have had the optional phono section or DAC card installed in the
PREAMPLIFIER , the interconnects from the turntable or digital source should be installed
into INPUT 1. For more information about the phono option or DAC option, please contact
your dealer.
NOTE:
When using the phono card option, install RCA "shorting" plugs, available from your
JRDG dealer, into all unused RCA unbalanced inputs to prevent audible pops when switching
between inputs.
(2) BALANCED INPUTS:
components, they should be connected to balanced INPUTS 3 and 4. A slight mechanical
click may be heard when the balanced XLR interconnect cables are correctly installed and
locked into the rear panel connector. The unlocking tab must be pressed to disconnect the
XLR interconnect cable from the preampli er. The XLR inputs may be left open if unused.
Any XLR input can be converted to an RCA input by installing an XLR to RCA adapter,
available from your JRDG dealer.
NOTE:
Pin 2 of each XLR connector is signal positive with respect to each RCA input. Also, Jeff
Rowland Design Group recommends balanced cables as the preferred method of
interconnection.
(3) BYPASS INPUTS:
If the
system, the Left Front and Right Front output connections from the surround processor
should be installed in the BYPASS input connections. The
accept unbalanced RCA interconnects from the surround processor.
NOTE:
If an external surround sound processor is not connected, install RCA "shorting" plugs
to both bypass inputs.
(4) UNBALANCED LINE OUTPUTS:
unbalanced line level outputs. Use these outputs if your ampli er does not accept balanced
inputs. Also, these outputs can be used simultaneously with the balanced inputs to feed a
second ampli er (subwoofer, etc.)
NOTE:
Do NOT install RCA "shorting" plugs in the unbalanced line outputs.
(5) BALANCED LINE OUTPUTS:
balanced line level outputs.
(6) GROUND LUG THUMBSCREW:
phono section installed. When connecting a turntable, the ground or earth lead should be
connected to the Ground Lug Thumbscrew to eliminate any ground noise in the system.
If you are using unbalanced RCA interconnects from your source
If you are using balanced XLR interconnects from your source
CAPRI S2 PREAMPLIFIER
The CAPRI S2 PREAMPLIFIER
The CAPRI S2 PREAMPLIFIER
This connection is reserved for units with the optional
is installed in a home theater or sound
CAPRI S2 PREAMPLIFIER
also has one pair of RCA
also has one pair of XLR

REVA1.4 CAPRI S2 PREAMPLIFIER
CAPRI S2
will only

PAGE 14