Eaton Current-Limiting - Type NXC Fuse Installation Instructions Manual
Eaton Current-Limiting - Type NXC Fuse Installation Instructions Manual

Eaton Current-Limiting - Type NXC Fuse Installation Instructions Manual

C-rated

Advertisement

Fusing Equipment
MN132014EN
Current-Limiting – Type NXC® (C-Rated) Fuse
Installation Instructions
Effective November 2016
Supersedes July 2005 (S240-61-1)
COOPER POWER
SERIES

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Current-Limiting - Type NXC Fuse and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Eaton Current-Limiting - Type NXC Fuse

  • Page 1 COOPER POWER Fusing Equipment SERIES Effective November 2016 MN132014EN Supersedes July 2005 (S240-61-1) Current-Limiting – Type NXC® (C-Rated) Fuse Installation Instructions...
  • Page 2: Disclaimer Of Warranties And Limitation Of Liability

    CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to...
  • Page 3: Table Of Contents

    Contents DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii SAFETY FOR LIFE .
  • Page 4: Safety For Life

    FOR LIFE FOR LIFE Eaton meets or exceeds all applicable industry standards relating to product safety in its Cooper Power™ series products. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing, and service.
  • Page 5: General

    Current-Limiting – Type NXC® (C-Rated) Fuse General Bolt or Stud Mounting Standard safety procedures should be followed when Bus Bar removing and installing NXC fuses on capacitor blocks. ® NXC Fuse Removal 3.0" Remove all power from capacitor block. ", -0") Blown Fuse Allow capacitors to discharge internally for five minutes;...
  • Page 6 3.0" 1 / 2 ", -0") CAUTION This product as designed and packaged by Eaton is classified by the USDOT as Not Regulated as an Explosive . The leader wire must be held in place by Capacitor attaching the wire under the hex-head bolt or clamped to the fuse body to maintain this classification when an un-operated fuse is transported .
  • Page 7 Current-Limiting – Type NXC® (C-Rated) Fuse his page is intentionally left blank. InstallatIon InstructIons MN132014EN November 2016...
  • Page 8 2300 Badger Drive Waukesha, WI 53188 United States Eaton.com/cooperpowerseries © 2016 Eaton All Rights Reserved Eaton is a registered trademark. For Eaton‘s Cooper Power series product Printed in USA information Publication No. MN132014EN call 1-877-277-4636 or visit: All trademarks are property www.eaton.com/cooperpowerseries.

This manual is also suitable for:

Cooper power series

Table of Contents