Description Of Connectors; Led Indicators - Televes T.OX Series Quick Installation Manual

Description of connectors

Front view
1.- ASI input
2.- ASI output
3.- Power connectors
4.- Ethernet connector
5.- Ethernet connector
6.- Programmer connector
7.- RF loop through input
8.- RF output

LED indicators

Solid green
TEMP
Slow blink orange
Fast blink red
Off
CH1 – CH2 Solid green
Solid red
Front LED alarms
Blinking red
Solid green
OUTPUT
Slow blinking green
Solid orange/red
LOOP Solid green
Off
Back LED indicators A/V inputs Indicate the currently selected audio and video inputs and where the input signals should be connected.
Color Internal temp
Normal
High
Very High
Color Channel status
Disabled
Lock
Unlock
Boot
Color Output mode
Normal
Carrier wave, null, or muted
Normal
Color Output loop status
ON
OFF
Rear view
1.- YPbPr component input. Channel 1
2.- Closed Caption (CC) input. Channel 1
3.- Analog (L/R) audio input. Channel 1
4.- HDMI input. Channel 1
5.- SPDIF digital optical audio input. Channel 1
6.- SPDIF digital coaxial audio input. Channel 1
7.- SPDIF digital coaxial audio input. Channel 2
8.- SPDIF digital optical audio input. Channel 2
9.- HDMI input. Channel 2
10.- YPbPr component input. Channel 2
11.- Closed Caption (CC) input. Channel 2
12.- Analog (L/R) audio input. Channel 2
Comment
Safe
Warning
Danger
Comment
Channel disabled
Input locked and unit encoding audio/video.
Input unlocked and unit not encoding audio/video.
Unit starting up.
Comment
Output RF channel is ON, broadcasting audio/video (normal mode).
Output RF channel is OFF or in an alternate signal mode.
Config bitrate doesn't fit in output
Comment
Output loop-through enabled. Units may be daisy-chained using the internal combiner.
Output loop-through disabled. Units must be combined using an external combiner.
4
5
6
9
11