Yale ERP15-20VT Service Manual page 23

1800 YRM 1332
1. CLAMP
2. MAIN PRESSURE
LINE
3. ELBOW FITTING
4. TRANSDUCER
5. MASTER
CYLINDER
Figure 3. Pedal Retaining Nut
5. Remove three mounting capscrews and nuts secur-
ing bracket to frame.
6. Lift brake pedal assembly from the lift truck.
DISASSEMBLE
For the following procedures, see Figure 3, Figure 4,
and Figure 5.
1. Remove master cylinder if necessary. See Master
Cylinder Repair, in this section.
2. Remove brake pedal:
a. Remove the return spring. See Figure 4.
b. Pull the cotter pin and remove clevis pin and
washer from the clevis if the master cylinder
has not been removed. Discard the cotter pin.
6. BRACKET
7. BOLT
8. NUT
9. MOUNTING
CAPSCREWS AND
NUTS
10. PEDAL
Brake Pedal Assembly Repair
c. Remove nut, then slide bolt from assembly.
See Figure 3 and Figure 4.
d. Lift pedal from assembly. Recover washer and
sleeve from pedal. See Figure 5.
e. Remove bushings from pedal if necessary.
1. PEDAL
2. RETURN SPRING
3. WASHER
4. CLEVIS PIN
Figure 4. Pedal Assembly and Linkage
1. WASHER
2. BUSHING
3. SLEEVE
Figure 5. Pedal Bushings
5. COTTER PIN
6. CLEVIS
7. BOLT
4. BUSHING
5. PEDAL
3