Adding A New Circuit - I2M Chrome Lite User Manual

•
Go to the "Data Acquisition" menu, change the following parameters; Recording: ACTIVE,
Sampling Frequency: 100Hz, Lower Speed: 20km/h, Autostart Channel: SPD1
•
Now start the motorbike, change gears from N,1,2,3,4,5,6 maintaining 20sec intervals (ensure that
the REC icon is active on the startup screen)
•
Upon completion, kill the ignition and select the "Inputs & Special Functions/Configure
Inputs/Configure gears (no CAN)"
•
Once done you can configure the gear acquisition again if required
The Chrome unit calculates gear indication referring to sessions of the day, therefore the procedure can
simply be performed utilizing a dyno tune facility or a race circuit. Ensure that all the gears are properly
engaged and that the data calculation is done on the same day and location.

Adding a New Circuit

There are two options available for adding new circuits to the Chrome unit;
1) Update the Danas circuit library
2) Modify existing circuit on the Chrome unit
Update the Danas circuit library
To update the current Danas circuit library, open Danas on your personal computer and navigate to
"Online/Configure Chrome Circuits". The list will have all the circuits available, add new circuits with the "+"
icon (always ensure that the complete list has a minimum & maximum of 20x circuits).
Once all circuits have been selected move the "CircuitInOut.ccr" file to a USB flash drive (FAT32/exFAT
formatting with 1 partition only). Now connect the USB flash drive to the Chrome unit and import the
circuits via the "Chronometer/Export & Import/Import Cicuits from USB" menu.
CAUTION:
The circuits must be exactly 20x in total, do not import less than or greater than 20x circuits as this will
cause the unit to malfunction.
Modify existing circuit on the Chrome unit
•
In the Chrome units menu select "Chronometer/Select Circuit" to open the circuit list, proceed to
select the required circuit or select a circuit that is FREE/can be replaced.
•
Proceed to navigate to "Chronometer/Circuit Details/Update Name" to change the circuit name and
to manually select the finish line position, change "Update Finish Line Position" to "UPDATE",
ensure the units position is on the finish line prior to confirmation. Alternatively, select the "AUTO"
function for automatic configuration.
•
When the "AUTO" function is selected, the system will automatically set the finish line position when
the motorcycle exceeds a 150km/h thus starting the lap timer at that point.
•
Once the session is finished, the user can move the finish line and/or split positions on the "MAP"
in the "Update Finish Line Position" selection.
Exit Standby Mode and Shutdown
If the standby time has been configured the Chrome unit will turn off the display and some peripherals (not
the GPS) in order to reduce power consumption. The unit will automatically shut down after the set standby
time has lapsed. If the user would like to turn off the unit prior, follow the below instructions;
•
Turn off the Chrome unit
•
Wait until the LED in the bottom right corner flashes
•
Press the DN button until the red LED above the gear indicator illuminates
•
Release the DN button
•
After 2-3 seconds the upper white LED will flash, this indicates that the Chrome has successfully
shut down
www.i2m.it/en
15