Bosch SSB1000 SA Manual page 33

Relevant variables
Specific Parameters
DHW_Mode
DHW_Store_Setpoint
Sets the supply temperature from primary heat exchanger to prepare DHW
in the indirect tank.
DHW_Store_Hyst_Down
Hysterese to start burner for DHW. Condition: T_Supply below DHW_
Supply_Setpoint less DHW_Supp_Hyst_Down.
DHW_Store_Hyst_Up
Hysterese to stop burner for DHW. Condition: T_Supply above DHW_
Supply_Setpoint plus DHW_Supp_Hyst_Up.
DHW_Store_Supply_Extra
Increases the supply temperature to the indirect tank until DHW_Store_
Setpoint + DHW_Store_Supply_Extra.
DHW_Priority
DHW_Max_Priority_Time
Sets the maximum time for either DHW or CH priority.
DHW_Post_Pump_Period
DHW_PID_P_Store
DHW_PID_I_Store
DHW_PID_D_Store
SSB
(Default) Value
Level
°C
2: Installer 0
[°C/°F] 2: User 57
[°C/°F] 3. Factory 5
[°C/°F] 3. Factory 5
[°C/°F] 2: Installer 15
[-] 2
[min] 2: Installer 60
[sec] 2: Installer 120
3. Factory 100
3. Factory 50
3. Factory 0
Main control | 33
Settable
°F °C °F
0, 1, 2, 3, 5, 6, 7, 8
135 40..85 104..185
9 0..20 0..36
9 0..20 0..36
27 0..30 0..54
0 ¨ Time
1 ¨ Off
2 ¨ On
3 ¨ Parallel
10..900
0..1275
0..1275
0..1275
6720892984 (2019/02) US