Table of Contents
Advertisement
Compliance to standards based Dual Radio, 2x2, 802.11n
Dual Radio, 2x2, 100mW, Internal Antenna
Shall support Dual Concurrent Radios
Dual Radio, 2x2, 100mW, Internal Antenna
Shall support limited lifetime warranty
Operating Temp: 0ºC to 40ºC
Storage Temp: -30ºC to 70ºC
Operating Humidity: 10% to 90% Non-condensing
Storage Humidity: 5% to 95% Non-condensing
The PCB must include a printed "Manufactured for Cisco" marking
(using the Cisco Logo as shown in EDCS-775872. The minimum width
of the Cisco logo is ½". The location is preferable on the top of the PCB,
but the back is acceptable if spacing doesn't allow it to be on the top. It
cannot be underneath a soldered component (but can be underneath a
mini-PCI card if one exists).
3
Advertisement
Table of Contents
