Vollrath LidSaver 2 Operator's Manual

LOADING INSTRUCTIONS

LS02M Mini Lid and Condiment Cup Dispensers
1. Before loading lids, verify your lids match the manufacturer and
lid number noted on the lid plate label.
2. Open the door past 90 degrees. It will stay open.
3. Separate the lids prior to loading to release any lids that may have been
pressed together during packaging.
4. Load lids or cups.
• Lids must be loaded with the front of the lid stack facing forward.
• Cups must be loaded with the bottom of the cup stack facing forward.
NOTICE: DO NOT overstock lids. Compressing lids may result in
dispensing problems.
5. If dispensing tabbed lids, align all lid tabs either up (12:00) or
down (6:00) to avoid interference with the lid claws.
NOTICE: Each LidSaver™ is factory set to dispense a particular lid or
cup. If you change manufacturers or sizes, your LidSaver™ 2
will need to be modified. Vollrath offers lid change out kits
that are easy to install. Visit www.Vollrath.com for more
information.
LidSaver
LS02I and LS02P Lid Dispensers
1. Before loading lids, verify your lids match the manufacturer and lid
number noted on the lid plate label.
2. Pull the door open past 90 degrees. Push the button on the side of the
housing. This will enable the door to stay open for easy loading.
3. Separate the lids prior to loading to release any lids that may have been
pressed together during packaging.
4. Load lids or cups.
• Lids must be loaded with the front of the lid stack facing forward.
NOTICE: DO NOT overstock lids. Compressing lids may result in
5. If dispensing tabbed lids, align all lid tabs either up (12:00) or
down (6:00) to avoid interference with the lid claws.
NOTICE: Each LidSaver™ is factory set to dispense a particular lid. If
6. Gently pull door open past 90 degrees and then release the door. It will
automatically close.
Please register your product at Vollrath.com
©
2016 The Vollrath Company L.L.C.
Operator's Manual
™
2 Dispenser Cabinets
dispensing problems.
you change manufacturers or sizes, your LidSaver™ 2 will
need to be modified. Vollrath offers lid change out kits that
are easy to install. Visit www.Vollrath.com for more
information.
Part No. 350393-1 en 5/31/16