Mayline DUAL COLUMN 2 STAGE BASES Assembly Instructions

Advertisement

NOTE: Please count and inspect all pieces before disposing of any carton or packing materials.

COMPONENTS:

REF. #
QTY.
1
2
2
2
3
2
4
2
5
2
6
1
7
1
8
2
9
1
**OPTIONAL MEMORY SWITCH - 523MC
HARDWARE BAG (For any missing components order PART No. A9292)
REF. #
E1
E2
E3
E4
REPLACEMENT LEVELER
QTY 1
PART# Q714
I923 Rev 2 2/17
ASSEMBLY INSTRUCTIONS
for DUAL COLUMN
2 and 3 STAGE BASES
When ordering components, specific size information may be required.
Contact a Mayline Customer Service Representative.
DESCRIPTION
LIFT ACTUATOR
FOOT w/LEVELERS
ACTUATOR FRAME
ADJ. CROSS BAR
TOP SUPPORT BRKT
CONTROL BOX
STD. SWITCH
MOTOR CABLE
WIRE CHANNEL
QTY.
DESCRIPTION
12
M6 x 15mm MACHINE SCREW
LOCK WASHER
FLAT WASHER
19
5x20mm PAN HD WOOD SCREW
8
4mm SET SCREW
1
4mm HEX WRENCH
PART No.
-
5122F2S (22" 2 Stage) - 5122FS (22" 3 Stage)
5126F2S (26" 2 Stage) - 5126FS (26" 3 Stage)
-
-
A9284S
Z529 (2 Stage) - Z530 (3 Stage)
523SC
-
-
OPTIONAL CASTERS -QTY 4
2 LOCKING/2 NON-LOCKING
PART# Q715
(1)
1-800-822-8037

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DUAL COLUMN 2 STAGE BASES and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Mayline DUAL COLUMN 2 STAGE BASES

  • Page 1 2 and 3 STAGE BASES NOTE: Please count and inspect all pieces before disposing of any carton or packing materials. When ordering components, specific size information may be required. COMPONENTS: Contact a Mayline Customer Service Representative. 1-800-822-8037 REF. # QTY.
  • Page 2 1. Remove the Actuator/Frame Assembly (Parts 1,3,4) from the carton and place on a clean flat surface with the frame down. 2. Carefully unfold the Lift Actuators (1) to the vertical position. 3. Separate Actuator Frames (3) from Adj Cross Bars (4) enough to expose the mounting holes in the Actuator Frame.
  • Page 3 7. Place Table Top down on a clean, flat, non-abrasive surface. Place Actuator/Frame assembly in mounting location on top. Note: Use pilot holes and Top Support Brkt as a guide. Note: Cross Bar adjustment will be required. Adjust Cross Bar (4) so Mounting Straps/Cord Passage Holes are approximately centered in the frame.
  • Page 4 11. Position Switch (7) on desired location on front edge of top, and fasten with Screws (E4), Qty 2. 12. Position Control Box (6) and Wire Channel (9) in desired location, and fasten with Screws (E4), Qty 7.
  • Page 5 13. Carefully plug Motor Cables (8), Switch Cord, and Power Cord into matching ports on Control Box. Use the Diagram below as a guide. 14. Using one person per side, Carefully rotate table onto the base. 15. Plug power cord into outlet and proceed with Switch Initialization. See User Manual.

This manual is also suitable for:

Dual column 3 stage bases

Table of Contents