Deadbreak connectors, insulated protective cap (4 pages)
Summary of Contents for Eaton Tandem ELF Current-Limiting Dropout Fuse
Page 1
COOPER POWER Fusing Equipment SERIES Effective November 2016 MN132029EN Supersedes June 2010 (S240-67-1) Tandem ELF Current-Limiting Dropout Fuse Installation Instructions Upper pull ring connector Upper contact Pull ring Backup current- limiting fuse Fuse cap Fuse link holder Lifting eye...
Page 2
CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or other-wise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to...
FOR LIFE FOR LIFE Eaton’s Cooper Power series products meet or exceed all applicable industry standards relating to product safety. We actively promote safe practices in the use and maintenance of our products through our service literature, instructional training programs, and the continuous efforts of all Eaton employees involved in product design, manufacture, marketing and service.
Tandem ELF current-limiting dropout fuse installation instructions CAUTION Upper pull ring connector Eaton’s Cooper Power series Tandem ELF Fuse is Upper contact designed to be installed in accordance with normal safe operating procedures . These instructions are not Pull ring intended to supersede or replace existing safety and operating procedures .
Table 2. 12/20.8 12.7/22.0 – For further information concerning the coordination of the 12.47 13.2 – Tandem ELF fuse see Eaton’s Cooper Power series catalog 13.2/22.9 14/24.2 – section CA132028EN or contact your Eaton representative. 13.2 13.9 –...
Tandem ELF current-limiting dropout fuse installation instructions Installing a fuse link in fuse link holder Remove the hook stick. Take a position well clear of the vented end and Remove the fuse cap from the middle connector of exhaust path of the cutout in the closed position and the fuse link holder assembly.
Tandem ELF current-limiting dropout fuse installation instructions Perform a continuity check on the backup WARNING current-limiting fuse as shown in Figure 7 . Do not attempt to interrupt load current by pulling on CAUTION the Tandem ELF fuse pull ring to open the cutout . An arc started by opening a cutout under load in this manner Failure to check the Tandem ELF’s backup current-...
Tandem ELF current-limiting dropout fuse installation instructions Refusing the backup current-limiting fuse Hardware Upper Remove the backup current-limiting fuse by Pull ring connector unbolting it from the middle connector . Unbolt the upper pull ring connector from the Backup current-...
Page 10
Tandem ELF current-limiting dropout fuse installation instructions This page is intentionally left blank. INSTALLATION INSTRUCTIONS MN132029EN November 2016...
Page 11
Tandem ELF current-limiting dropout fuse installation instructions This page is intentionally left blank. INSTALLATION INSTRUCTIONS MN132029EN November 2016...