Download  Print this page

Installation - AEG IKE64651FB User Manual

Hide thumbs

Advertisement

Problem
There is no sound when you
touch the panel sensor
fields.
comes on.
and a number come on.
You can hear a constant
beep noise.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure,
you operated the hob correctly. If not the

8. INSTALLATION

WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
Possible cause
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is an error in the hob.
The electrical connection is
incorrect.
servicing by a service technician or
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre and
conditions of guarantee are in the
guarantee booklet.
8.3 Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable,
use the cable: H05BB-F or H03V2V2-F
which withstands a temperature of
70°C or higher.
ENGLISH
Remedy
Activate the sounds. Refer to
"Daily use".
Refer to "Daily use".
Deactivate the hob and acti-
vate it again after 30 sec-
onds. If
comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
17

Advertisement

loading