HRC 390 SERIES
Quic k Start i nS t r u c ti o n S
Step 1 Power Up: remove the contact
strip from the battery compartment to activate
battery power. if back light is needed plug the
timer into a 110 v outlet and the screen will
light up.
Step 2 Programming Tool: obtain the
stylus by removing it from its holster located
on the back of the controller module.
Step 3 Press Reset: use stylus to press
the reset button. all functions will appear then
quickly disappear to indicate the timer has
been activated and made ready for program-
ming.
Step 4 Set Language: using the stylus to
navigate the
/
select your preferred pro-
gramming language English, Espanol, Fran-
cais, Deutsch, italiano then press "EntEr".
Step 5 Set Time and Date: using the
stylus to navigate the
then press "EntEr". Follow similar process as
the controller directs you to
"EntEr" ,
"SEt
MontH",
Step 6 Set Program Start Times: using
the stylus toggle to the desired program a, B,
or c by touching the on screen . using the sty-
lus to navigate the
time for each program then press "EntEr".
proof no:
date:
des:
client:
sku:
p 801 295 9820
upc:
f 801 951 5815
file name:
www.fluid-studio.net
1065 South 500 West
software:
Bountiful, Utah 84010
/
select current time
"SEt
YEar" then
"SEt
DaY".
A
/
select preferred start
1
dimensions:
flat: w: 6.5" h: 5.5"
finished: w: 6.5" h: 5.5"
10.26.11
colors
MZ
Hydro-Rain
04040
N/A
additional instructions:
04040-50 rA.indd
InDesign CS5
Step 7 Set Water Days: using the stylus
toggle to the desired program a, B, or c by
touching the on screen . Select specific days
of the week or
oDD
tEr". Should you select
/
to select 1 to 32 days then "EntEr".
Step 8 Set Station Duration: using the
stylus toggle to the desired program a, B, or c
by touching the on screen . using the stylus
to navigate the
that station "1" will water then press "EntEr".
or, select minutes by selecting the box marked
0, 5, 10, etc... then press "EntEr". Follow the
same progression for all remaining needed
stations.
PROGRAMMING IS NOW COMPLETED
PRESS "ENTER": if you have removed the
module from the power box replace it and
make sure the unit is plugged into a 110 v out-
let or hard wired to 110v power. this control-
ler will not operate valves running on battery
power.
color
Registration
non printing
PMS
K
2955
A
or
EVEn
days then
"En-
intErVaL
use the
A
/
select preferred 1 to 240
04040-50 ra
color
non printing
PMS
PMS
????
????
Printers are
responsible for
meeting print
production
requirements.
Any changes
must be approved
by the client and
Fluid Studio.
Printed piece
must meet
designated
specifications
on this form.
Need help?
Do you have a question about the HRC 390 SERIES and is the answer not in the manual?
Questions and answers