Connecting Your Computer/Connecting The Power Cord - NEC P525UL User Manual

2-2. Connecting Your Computer/Connecting the Power Cord

1. Connect your computer to the projector.
This section will show you a basic connection to a computer. For information about other con-
nections, see "5. Making Connections" on page 81.
Connect the computer cable (VGA) between the projector's COMPUTER IN terminal and the
computer's port (mini D-Sub 15 Pin). Turn two thumb screws of both terminals to fix the com-
puter cable (VGA).
2. Connect the supplied power cord to the projector.
First connect the supplied power cord's three-pin plug to the AC IN terminal of the projector,
and then connect another plug of the supplied power cord directly in the wall outlet. Do not
use any plug converter.
CAUTION:
This equipment is designed to be used in the condition of the power cord connected to
earth. If the power cord is not connected to the earth, it may cause electric shock. Please
make sure the power cord is earthed properly.
When the power cord is connected, the POWER indicator of this projector flashes orange and
the unit goes into the standby mode. (In the state, [STANDBY MODE] is [NORMAL].)
COMPUTER IN
Computer cable (VGA)
(supplied)
Make sure that the prongs are fully inserted
into both the AC IN and the wall outlet.
2. Projecting an Image (Basic Operation)
16
To wall outlet