NEC P525UL User Manual page 162

Indicator Message (Error message)
POWER STATUS
Blue Orange
(Light) (Light)
Blue Orange
(Light) (Blink* )
4
Blue Off
(Light)
Red Off
(Blink* )
3
Status varies Off
Red Status varies
(Light)
*3 Repetition to light on for 0.5 seconds / off for 0.5 seconds
*4 Repetition to light on for 0.5 seconds / off for 2.5 seconds
LIGHT Projector status
A button has been pressed while
the [CONTROL PANEL LOCK] is
activated.
Status varies
ID numbers for the projector and
the remote control do not match.
Network conflict
Status varies
Temperature problem (In the
Forced ECO mode)
Orange
(Light)
Temperature problem
Off
Hardware problem
Red
(Blink* 3 )
Error requiring service support
Status varies
The projector's keys are locked.
The setting must be canceled to
operate the projector. (→ page
69)
Check the control IDs (→ page 70)
Both the built-in wired LAN and
the wireless LAN cannot be con-
nected to the same network at
the same time.
To use both built-in wired LAN
and wireless LAN at the same
time, connect them to different
networks.
NOTE: In the Standby condition,
the status indicator on the cabi-
net does not blink in orange even
if the network conflicts.
Ambient temteprature is high.
Lower the room temperature.
Ambient temperature is out of
the operation temperature. Check
if any obstruction stays near the
exhaust vent.
Problem with the hardware.
Contact your dealer.
Contact your dealer or service
personnel. Make sure to check
and inform indicator status for
asking to repair.
142
9. Appendix
Procedure