Commodore 16 User Manual page 86

by an illegal number of file names.
or patterns are illegally used. For
example. two Me names may
appear on the left side of the
COPY command
The DOS does not recognize the
command The command must
start in the first position.
The command sent is longer than
58 characters
Pattern matching is invalidly used
in the OPEN or SAVE command
The file name was left out of a
command or the DOS does not
recognize it as such. Typically.
a colon() has been fell out of
the command
.
This error may result if the com-
mand sent to command channel
(secondary address 15) is unrec-
ognized by the DOS
.
52
FILE TOO LARGE
60
WRITE FILE OPEN
61
FILE NOT OPEN
62
FILE NOT FOUND
63
FILE EXISTS
64
FILE TYPE MISMATCH
NO BLOCK
turn which is sent as a record ter-
minator is counted in the record
size. this message will occur it the
total characters in the record (in-
cluding the final carriage return)
exceeds the defined size .
Record position within e relat ive
Me indicates that disk overflow
will result.
This message Is generat ed
when a write liie that has not
been closed is being opened
for reading
This message is generated when
a file is being accessetl that has
Sometimes. in this cast. a mes-
sage
been opened in the DOS.
sage is not generated; the re-
quest is simply ignores.
The requested file does not exist
on the indicated drive.
The file name of the file being
created already exists on the
diskette.
The file type does not match the
file type in the directory entry for
the requested file.
This message occurs in conjunc-
tion with the B-A command It
indicateS that the block to be allo-
cated has been previously allo-
cated. The parameters indicate
the track and sector available
with the net highest number. It
the parameters are zero (0). then
all blocks higher in number are
in use
31
SYNTAX ERROR
(invalid command)
32
SYNTAX ERROR
(invalid command)
33 SYNTAX ERROR
(invalid file name)
34 SYNTAX ERROR
(no file giver)
39
SYNTAX ERROR
(invalid command)
50 RECORD NOT PRESENT Result of disk reading past the
last record through INPUTS, or
GETS commands This message
will also occur after positioning to
a record beyond end of Me in a
relative file II the intent is to ex-
pand the Me by adding the new
record (with a PRINTS com-
mand), the error message may be
ignored INPUT or GET should not
be attempted after this error is de-
tected without first repositioning
5'
OVERFLOW IN RECORD PRINTS statement exceeds
record boundary. Information is
truncated. Since the carriage re-
168
169