To Move Machine Without Power; Moving Machine On Caster - National 5600 Instruction Manual

JOB SITE MOVEMENT

TO MOVE MACHINE WITHOUT POWER

(PUSHING MACHINE)
Forward: To move the machine forward, levers need to be pushed forward. To lock levers in place,
connect a bungee-strap from each lever (pushing levers forward), pulling straps down to and connecting
to the front plate (See Figure A). Never leave machine unattended with strap holding levers open.
Backward: To move machine backward, levers need to be pulled backwards. To lock levers in place,
connect a bungee-strap from each lever (pushing levers backward), Pulling straps to the back of the
machine and connecting behind the seat or the rear of the machine (See Figure B). Never leave machine
unattended with strap holding levers open.

MOVING MACHINE ON CASTER

Moving a "weighted" machine only on the front caster and not on the cutting head or the Front Wheel
Assembly can seem to make the machine turn sluggish. It might turn hard to the right or the left. This is
normal.
WARNING: Always remove straps before starting motors. Failure to do so will make machine
move and may cause property damage and/or bodily injury.
FORWARD
BACKWARD
Figure A Figure B
Page 28