Center Of Gravity - National 5600 Instruction Manual

CENTER OF GRAVITY

Be aware of your surroundings and machines operating angles. When changing from a low slide plate to
a high slide plate setting or a low cutting head angle to a high cutting head angle, the operating "attitude"
of the machine changes. When a floor surface is not level (ramps, inclines, large amounts of debris which
would lift the drive wheel of the machine, etc.), the center of gravity changes. Too much of an angle could
make the machine unsafe (a cause for tip-over). Do Not run the machine in unsafe environments.
CAUTION: MACHINE IS BACK HEAVY. CAUTION: MACHINE IS BACK HEAVY.
DO NOT RUN ON STEEP INCLINE-- DO NOT RUN ON STEEP INCLINE--
THIS COULD CAUSE MACHINE TO TIP OVER! THIS COULD CAUSE MACHINE TO TIP OVER!
Page 26