Cisco RV260 series Administration Manual page 72

Basic Settings
Actively applied to Radio
SSID Broadcast
Security Mode
Passphrase
PMF (Protected Management
Frames
RV260x Administration Guide
64
Select 2.4G or 5G band to connect only to a network matching both network settings
and band selection. The SSID is created on the radio selected.
Select Both to configure the SSID on both the radios and connect this profile to an
available network with matching network settings.
Check Enable to enable SSID broadcasting if you want to allow wireless clients within
range to detect this wireless network when scanning for available networks. Disable this
feature if you do not want to make the SSID known. If disabled, the wireless client can
connect to your wireless network only if they provide the SSID and the required security
credentials.
Choose a security mode for the network from the following:
• None: Select this option for an unsecured network.
• WEP-64: Select the 64-bit WEP security mode and enter a WEP Key if you are
using old equipment that does not support WPA or WPA2 security. The WEP key
is a string of 10 hexadecimal characters.
• WEP-128: Select the 128-bit WEP security mode and enter a WEP Key if you are
using old equipment that does not support WPA or WPA2 security. The WEP Key
is a string of 26 hexadecimal characters.
• WPA2-Personal: Select Wi-Fi Protected Access II (WPA2) security protocol for
stronger security. If selected, enter an alphanumeric pass phrase.
• WPA2-Personal Mixed : Select this security protocol for stronger security when
you allow both WPA and WPA2 clients to connect simultaneously. If selected,
enter an alphanumeric passphrase.
• WPA2-Enterprise: Select this security protocol to use RADIUS server
authentication. If selected, specify the following:
• RADIUS Server IP Address (handles client authentication).
• RADIUS Server Port (port used to access the RADIUS server).
• RADIUS Secret (shared RADIUS secret).
• WPA2-Enterprise Mixed: Select this security protocol to use the RADIUS server
authentication when you allow both WPA and WPA2 clients to connect
simultaneously. If selected, specify the RADIUS Server IP Address, RADIUS
Server Port, and RADIUS Secret.
Enter the passphrase.
If using a passphrase, check Show Passphrase to make the passphrase visible.
Note
Wi-Fi certified WPA2 with PMF provides a WPA2-level of protection for unicast and
multicast management action frames. Check one of the following options:
• Not Required
• Capable
• Required
Wireless