Cisco RV260 series Administration Manual page 57

WAN
MPPE Encryption
If the IPv4 uses L2TP to connect, configure the following:
IP Assignment
L2TP Server IP/FQDN
Username
Password
Show Password
DNS Server
Static DNS 1 & 2
Connection on Demand
Keep Alive
Authentication Type
If the IPv6 Uses SLAAC to Connect
In the SLAAC Settings section, enter the following information:
Static DNS 1 & 2
DHCP-PD (IPv6 only)
Step 5 Click Apply.
For Advanced Settings
Step 6
Click the Advanced Settings tab and configure the following:
WAN VLAN Tag
VLAN ID
MTU– Maximum Transmission Unit
MAC Address Clone
When MAC Address Clone is enabled, the port mirroring does not work.
Note
Check to enable MPPE encryption.
For DCHP, select this option to enable DHCP to provide an IP address. For Static IP,
select this option and provide an IP address, netmask, and the IP address of the default
gateway.
Enter the name of the server.
The username assigned to you by the ISP.
The password assigned to you by the ISP.
Check to display the password.
Select Use L2TP Provided DNS Server or Use DNS.
Enter the IP address of the primary and or secondary Static DNS in the fields.
Select Connection on Demand if your ISP charges when connected. Enter the maximum
idle time, in seconds, to wait before terminating the connection due to inactivity. Default
is 5 minutes.
Select Keep Alive to periodically check the connection, and to re-establish the connection
when it is disconnected.
Select the authentication type from the drop-down list (Auto Negotiation, PAP, CHAP,
MS-CHAP, MS-CHAPv2).
Enter the IP address of the primary and or secondary Static DNS.
Check to enable and enter a prefix name.
Check to enable the WAN VLAN tag.
Enter the VLAN ID.
Select Auto to set the size automatically. To set the MTU
size manually, select Manual and enter the MTU size. (The
size in bytes of the largest protocol data unit that the layer
can pass.).
Check MAC Address Clone and enter the MAC address.
Click Clone My PC's MAC to use the MAC address of
your computer as the clone MAC address for the device.
RV260x Administration Guide
WAN Settings
49