Disassembly Procedures For Models Listed - Maytag AKS3040 Series Service Manual

Disassembly Procedures
To avoid risk of electrical shock, personal injury or death, disconnect power to cooktop before servicing, unless
testing requires power.

Disassembly Procedures for Models Listed

• JGC9430ADB/F/N/S
• JGC9536ADB/F/N/S
Main Top Removal
1. Shut off gas supply and disconnect electricity to unit.
2. Remove grates, caps, and knobs.
NOTE: To remove knob(s), slide a rag under the knob
and pull upward.
3. Remove cooktop from installation position and place
on protected surface.
4. Remove screws securing main top to burner box
bottom.
5. Remove main top by lifting off burner box.
NOTE: Screws under burner base act as orifice holder
guides.
6. Reverse procedure to reinstall.
Spark Module Removal Bottom Access
JGC9536AD* (If installation allows bottom access)
1. Gain access to the bottom of the cook top.
2. Remove screws securing spark module to access
panel.
3. Remove screws securing spark module to access
panel.
4. Disconnect and label wire leads from spark module.
NOTE: Mark wires for exact replacement on module.
5. Replace spark module and reverse procedure to
reinstall.
Spark Module Removal
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing spark module cover to
burner box.
3. Remove screws securing spark module to burner
box.
4. Disconnect and label wire leads from spark module.
NOTE: Mark wires for exact replacement on module.
5. Replace spark module and reverse procedure to
reinstall.
©2003 Maytag Appliances Company
!
WARNING
Surface Ignitor Removal
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing burner base to orifice
holder.
3. Lift up burner base and disconnect ignitor wire.
4. Remove screw securing ignitor to burner base.
9. Replace ignitor and reverse procedure to reinstall.
Burner Switch Removal
1. Remove main top, see "Main Top Removal"
procedure.
2. Disconnect wire from burner switch.
3. Slide burner switch up and off burner valve stem.
4. Replace burner switch and reverse procedure to
reinstall.
Manifold Pipe Removal
1. Remove main top, see "Main Top Removal"
procedure.
2. Slide burner switch up and off burner valve(s).
3. Disconnect gas supply tubing from burner valve.
4. Remove screws securing manifold pipe to burner
box bottom.
5. Disconnect gas supply line and remove regulator
from manifold pipe.
6. Replace manifold pipe assembly and reverse
procedure to reinstall.
16022158 Rev. 0 15