Installation - HELIX V EIGHT DSP Manual

Installation

Connection of HELIX V EIGHT DSP to the head
Caution: Carrying out the following steps will re-
quire special tools and technical knowledge. In or-
tions and follow all instructions in this manual (see
installed by an authorized HELIX dealer.
input can be assigned to any output using the
DSP PC-Tool software. The automatic turn-on
circuit does not work when using the pre-ampli-
V EIGHT DSP.
Important: It is strictly forbidden to use the
Highlevel Input
Input
radio.
2. Connecting the highlevel speaker inputs
nected directly to the loudspeaker outputs of an
OEM or aftermarket radio using appropriate ca-
bles (loudspeaker cables with 1 mm² / AWG 18
We recommend the following channel assign-
ment if a common car radio will be connected
speaker inputs. If only two channels will be con-
nected we recommend to use the channels A
and B.
Make sure that the polarity is correct. If one
this input is used the remote input (REM
automatically turn on once a loudspeaker signal
Attention: It is mandatory to properly adapt
the input sensitivity of the V EIGHT DSP to
the signal source in order to avoid damage
table on page 22.
the control 9 (see page 18 point 9; Input Sen-
sitivity
sible to change it internally by repositioning
REM
jumpers. Therefore dismantle the side panel
the four screws (two Philipps head screws and
Line
the bottom plate and get access to the jumpers.
The long jumper
channels A - D and the short jumper
there are two plug positions for each Jumper.
- following:
Jumper A
Overview plug-in positions:
A1
(Jumper A
(Jumper
Jumper B
A2 B2 B1
-
-
B,
19