Specifications - Simplicity 1692544 Operator's Manual

Specifications

NOTE: Specifications are correct at time of printing and are subject to change without notice.
ENGINE
11 HP I/C — Briggs & Stratton
Horsepower 10.5 HP @ 3600 rpm
Cylinders 1
Bore 3.44 In. (87 mm)
Stroke 3.06 In. (77 mm)
Displacement 28.4 Cu. In. (465 cc)
Construction Cast Iron Sleeves, Aluminum Crankcase
Electrical 12 Volt, 3 Amp D.C. Unregulated Battery:
System 200 Cold Cranking Amps, 23 min. Reserve
Capacity
Ignition Electronic, Solid State, Maintenance Free
Air Cleaner Reusable Oil Foam Element
Lubrication Splash Lube
Oil Capacity 3 Pints (1.42 L)
Fuel Capacity 2 Gal. (7.57 L)
Muffler Quiet Compact, Low Back Pressure
13 HP Diamond OHV — Briggs & Stratton
Horsepower 13 HP @ 3600 rpm
Cylinders 1
Bore 3.44 In. (87 mm)
Stroke 3.06 In. (77 mm)
Displacement 28.4 Cu. In. (465 cc)
Construction Cast Iron Sleeves, Aluminum Crankcase
Electrical 12 Volt, 3 Amp D.C. Unregulated Battery:
System 200 Cold Cranking Amps, 23 min. Reserve
Capacity
Ignition Electronic, Solid State, Maintenance Free
Air Cleaner Pre-Cleaned Air to Paper Filter
Lubrication Splash Lube
Oil Capacity 2 Pints (1.42 L)
Fuel Capacity 2 Gal. (7.57 L)
Muffler Quiet Compact, Low Back Pressure
14 HP Command™ — Kohler
Horsepower 14 HP @ 3600 rpm
Cylinders 1
Bore 3.43 In. (87 mm)
Stroke 2.64 In. (67 mm)
Displacement 24.3 Cu. In. (398 cc)
Construction Overhead Valve, Cast Iron Sleeves,
Aluminum Crankcase
Electrical 12 Volt, 15 Amp Alternator Regulated Battery:
System 200 Cold Cranking Amps
Ignition High Energy Electronic Ignition
Air Cleaner Ducted Paper Cartridge and Foam Pre-cleaner
Lubrication Full Pressure Lube with Oil Filter
Oil Capacity 4 Pints (1.9 L)
Fuel Capacity 2 Gal. (7.57 L)
Muffler Quiet Compact, Low Back Pressure
TRANSMISSION
Gear Models
Type Spur Gear
Material Gear: Powered Metal
Shaft: Hardened
Bearings: Needle Roller and Bushings
Lubrication Bentonite Grease. Transmission is a sealed unit.
Differential Bevel Gear Type
Gear Range Five Forward, One Reverse
Ground Speeds lst:
2nd:
3rd:
4th:
5th:
Reverse:
Hydro Models
Type Hydrostatic
Lubrication Transmission is a Sealed Unit
Differential Bevel Gear Type
Ground Speeds Infinite Forward: 0-5.2 MPH (0-8.4 km/h)
Reverse: 0-2.3 MPH (0-3.7 km/h)
CONTROLS
Steering Full Circle Steering Wheel
System Gear and Sector
Clutch/Brake Location Right Front
Pedal Combination Clutch/Brake Pedal
Parking Brake Dash Lock Finger Release
Ground Speed Dash Mounted
Shift Lever
Throttle Control Combination Speed & Choke Control on right side
of seat deck
Key Switch Starter and Magneto ON/OFF Switch located on
left side of seat deck
Mower Drive Electric Clutch PTO Switch located on right side of
seat deck
Mower Cutting Infinite Height Control on Steering Column
Height
CHASSIS
Frame Heavy Gauge , Deep Drawn Steel
Front Axle Self-Leveling Quick Hitch
Seat Deck Lightweight Polymer Alloy
Seat Molded Type with Foam Cushion and Spring
Construction
Front Wheels Tire Size 13 x 5.00-6
Pneumatic Inflation Pressure 10 -12 psi
(68 - 82 kPa)
Rear Wheels Tire Size 16 x 6.50-8
Pneumatic Inflation Pressure 10 -12 psi
(82 - 103 kPa)
Accessibility Seat Deck Tips Forward
Seat Type Bucket, High Back, Adjustable w/
Spring Suspension, Fore and Aft Adjustable
Fuel Tank Material: Non-Corrosive Polyethylene Alloy
Capacity: 2 Gallons (7.5 L)
Turning Radius Inside Rear Tire 12 In. (30.2 cm)
30
1.2 MPH (1.9 km/h)
2.4 MPH (3.9 km/h)
3.5 MPH (5.6 km/h)
4.4 MPH (7.1 km/h)
5.6 MPH (9.0 km/h)
2..0 MPH (3.2 km/h)