Apply Ams Changes; Field Communicator - Emerson Rosemount 248 Reference Manual

Reference Manual
00809-0100-4825, Rev CB
3.3.1

Apply AMS changes

Right click on the device and select "Configuration Properties" from the menu.
1.
2.
3.
3.4

Field communicator

The Field Communicator exchanges information with the transmitter from the control room,
the instrument site, or any wiring termination point in the loop. To assist communication,
connect the Field Communicator in parallel with the transmitter, as shown in
page
Communicator. Do not make connections to the serial port of the NICAad recharger jack in
explosive atmospheres. To use the Field Communicator in an explosive atmosphere, the
instruments in the loop should be installed according to intrinsically safe or non-incendive field
wiring practices.
When using a Field Communicator, configuration changes must be sent to the transmitter using
the "Send" key (F2).
For more information regarding the Field Communicator, see the Field Communicator
Reference Manual (http://www.fieldcommunicator.com/suppmanu.htm).
Configuration
From the bottom of the screen, choose Apply.
When an Apply Parameter Modification screen appears, enter the desired information
and choose OK.
After reading the warning provided, choose OK.
16. Use the loop connection ports, which are non-polarized, on the near panel of the Field
Section 3: Configuration
March 2014
Figure 2-6 on
25