Rosemount 248 Pc Programmer Kit Installation - Emerson Rosemount 248 Reference Manual

Reference Manual
00809-0100-4825, Rev CB
3.6.3

Rosemount 248 PC Programmer Kit installation

1.
a.
b. Install the MACTek HART Modem drivers completely before beginning bench
Note
For USB modem: Upon first use, configure appropriate COM ports within the Rosemount 248PC
software by choosing Port Settings from the Communicate menu. The USB modem driver
emulates a COM port and will add to available port selections in the software's drop-down box.
Otherwise software defaults to first available COM port, which may not be correct.
2.
a.
b. Attach the HART Modem in parallel with the load resistor and connect it to the PC
Please see
Table 3-3. Rosemount 248 Programming Kit Spare Part Numbers
Product description
Programming Software (CD)
Rosemount 248 Programmer Kit - USB
Rosemount 248 Programmer Kit - Serial
Configuration
Install all necessary software for Rosemount 248 PC configuration:
Install the Rosemount 248C software
– Place the 248C CD-ROM in the drive
– Run setup.exe from Windows NT, 2000, or XP
configuration with the Rosemount 248 PC Programming system.
Set up configuration system hardware:
Hook up the transmitter and load resistor (250-1100 ohms) wired in series with the
power supply. (The Rosemount 248 device will need an external power supply of
12-42.4 Vdc for configuration)
Table 3-3 for spares kit and re-order numbers.
Section 3: Configuration
Part number
00248-1603-0002
00248-1603-0003
00248-1603-0004
March 2014
41