Table of Contents
Advertisement
Safety Instructions
Safety Instructions
Please read this section carefully and observe the instructions for your own safety
and correct use of the device.
This chapter also contains information on approval and interference suppression
of your KFM15_e.
The device has been built and tested by Kontron Embedded Computers in
accordance with EN 60950/VDE 0805 and left the company in a perfectly safe
condition.
In order to maintain this condition and ensure safe operation, the user must
observe the instructions and warnings contained in this manual.
❏ The device must be used in accordance with the instructions for use.
❏ The electrical installations in the room must correspond to the requirements of
the respective regulations.
❏ Take care that there are no cables, particularly power cables, in areas where
persons can trip over them.
❏ Do not use a power cable in sockets shared by a number of other power
consumers. Do not use an extension cable.
❏ Only use the power cord supplied.
❏ The unit is only completely disconnected from the main power source when
the power cord is disconnected either from the power source or from the unit.
Therefore, the power cord and its connectors must always remain easily
accessible.
❏ Only devices and components which fulfill the requirements of a SELV circuit
(Safety Extra Low Voltage) in accordance with EN 60950 may be connected
to the interfaces of the system.
❏ All plugs on the connection cables must be screwed or locked to the housing.
6
15" Industrial LCD Monitor KFM15_e – User's Manual (Version 2.20)
Advertisement
Table of Contents
