Table of Contents
Advertisement
Installation Instructions
Please observe the described hints in the chapter "Safety
Instructions" and the specification listed in the chapter "Main
Specifications".
Instruction for Mounting
Please take into account the needed free space on the interface
side, before you install the monitor into an industrial cabinet, an
instrument panel or other cabinets.
You find the description of the interfaces being available in the
section "Interfaces".
Important Instructions!
KFM15_e has to be installed only by trained and qualified
personal.
Make sure there is sufficient air circulation around the device
when installing the KFM15_e.
The openings for cooling (on upper and bottom side of the device)
must not be obstructed.
When installing KFM15_e into an industrial cabinet, leave at least
5 cm (approx. 2") of free space around the unit to prevent the
device from possibly overheating!
The 19" industrial cabinet must stand firmly in place.
If further stabilisation is necessary, then bolt the industrial cabinet
to the floor or anchor it on the wall.
The voltage feeds must not be overloaded. Adjust the cabling and
the external overcharge protection to correspond with the
electrical values indicated on the type label.
The type label is located on the left side of the monitor.
15" Industrial LCD Monitor KFM15_e – User's Manual (Version 2.20)
Installation Instructions
23
Advertisement
Table of Contents
