Installation Instructions
Panel Mount Version
If you install the panel version of the KFM15_e into an instrument panel or other
cabinet, use the eight threaded studs M4 on the rear side of the front plate.
For the panel assembly, cut a window and eight pre-drill holes according
figure 6. The system must be attached firmly with eight M4 metric nuts. Before
mounting, remove the protective film on the rubber seal at the rear side of the
display front plate. The contact surface with the rubber seal must be clean and
flush.
Fig. 6: Hole pattern for the KFM15_e, Panel mounting
(all values in mm)
Rack Mount Version
If you install the rack mount version of the KFM15_e into a 19" industrial cabinet,
at the front plate four mounting holes, are at your disposal.
The system has a height of 7U and will be secured with four screws in the 19"
industrial cabinet.
24
15" Industrial LCD Monitor KFM15_e – User's Manual (Version 2.20)