Associated Research HYAMP III Quick Start Manual

Hide thumbs Also See for HYAMP III:

Quick Start Guide

SAFETY CHECKLIST

urvey the test station. Make sure it is safe & orderly.

lways keep unqualified/unauthorized personnel away from the test area.

amiliarize yourself with safety protocols in the event of a problem.

xercise caution and never touch products or connections during a test.

rain operators. Never touch clips directly and always connect the return lead first.

ou should always know when a test is being performed.

WARNING: THIS GUIDE WAS CREATED FOR OPERATORS HAVING SOME FAMILIARITY WITH ELECTRICAL SAFETY

TESTING. AN ELECTRICAL SAFETY TESTER PRODUCES VOLTAGES AND CURRENTS THAT CAN CAUSE HARMFUL

OR FATAL ELECTRIC SHOCK. TO PREVENT ACCIDENTAL INJURY OR DEATH, THESE SAFETY PROCEDURES MUST

BE STRICTLY OBSERVED WHEN HANDLING AND USING A TEST INSTRUMENT. CONTACT US AT

INFO@ARISAFETY.COM FOR MORE INFO ON HOW TO GET TRAINED ON ELECTRICAL SAFETY TESTING.

HYAMP

Models 3130, 3140, 3145, 3160

III

Table of Contents

Do you have a question about the HYAMP III and is the answer not in the manual?

Page 1 Quick Start Guide HYAMP ® Models 3130, 3140, 3145, 3160 SAFETY CHECKLIST urvey the test station. Make sure it is safe & orderly. lways keep unqualified/unauthorized personnel away from the test area. amiliarize yourself with safety protocols in the event of a problem. xercise caution and never touch products or connections during a test.
Page 2 EDIT SYSTEM PARAMETERS INSTRUMENT SETUP Configure the instrument system parameters to your preferences. The instrument WARNING: LOCATE A SUITABLE TESTING AREA WITH A THREE-PRONG, GROUNDED system parameters are global and will affect all tests that you perform regardless OUTLET. BE SURE THAT YOUR THREE-PRONG OUTLET HAS BEEN TESTED FOR PROPER WIRING.
Page 3 TEST CONNECTION WARNING: DO NOT TOUCH THE DEVICE UNDER TEST ONCE YOU START THE TEST. Settin g s M1-1 Menu Results Setting up a test connection on the HYAMP III is straightforward, but differs M1-1 1.0s Settin g s START ____________________________...
Page 4 Plug the red coded end into Hipot signal output. You can interconnect a HYAMP III to all Hypot III models to form a complete test • P/N 5030DT-22 - Plug the blue coded end into the Ground Bond signal system.
Page 5 Safety Is Our Only Focus ® For additional information about these and other key features of the HYAMP III, please consult the ® full Operation and Service Manual or call us toll-free 1-800-858-TEST (8378) or +1-847-367-4077 ©2017 Associated Research arisafety.com • FOLLOW US! 1/2017...

3130316031403145