Stamina 15-4800R Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 6
NOTE: RIGHT PEDAL(34)
The
has right hand threads and is tightened by turning clockwise. The
stamped on the end of the pedal shaft. The
tightened by turning counter clockwise.
RIGHT PEDAL(34)
Thread the
RIGHT PEDAL STRAP(80)
Select the
hole end onto the inside edge of the
RIGHT PEDAL(34)
holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the
LEFT PEDAL STRAP(79)
STEP 7:
Identify the
PULSE PLUG WIRE(36)
the
POST(81) FRONT FRAME(1)
into the
STEP 8:
Install two
detailed battery installation instructions. Plug the
PULSE PLUG WIRE(36)
and plug the
COMPUTER POST(25),
back into the
NOTE:
Be careful not to damage the wires when attaching the
R
has stamped on the end of the pedal shaft. The
onto the right side of the
which has
RIGHT PEDAL(34).
R
with the mark on the bottom of the
LEFT PEDAL(33)
LEFT PEDAL(33).
onto the
POST CAP(82)
on the
through the
and secure with
"AA"
batteries into the
into the back of the
then slide the
LEFT PEDAL(33)
CRANK(7)
R
marked on the bottom side of the strap. Snap the two
Snap the other end onto the outside edge of the
RIGHT PEDAL STRAP(80).
onto the left side of the
FRONT FRAME(1).
COMPUTER POST(81).
BOLT(M6 x 15mm)(83).
COMPUTER(26),
two batteries included. See page 14 for
SENSOR WIRE(27)
COMPUTER(26).
COMPUTER(26)
COMPUTER(26).
8
RIGHT PEDAL(34)
LEFT PEDAL(33)
has left hand threads and is
as shown. Tighten the pedal securely.
Select adjustment
CRANK(7)
SENSON WIRE(27)
Run the
Then insert the
COMPUTER(26)
into the wire on the
Push the excess wires
COMPUTER POST(25).
onto the
L
has
and snap the
and
COMPUTER