Binding; Changing The Throttle Limit; Getting Started - Horizon Hobby ECX AXE ECX03056 Instruction Manual

EN

BINDING

Binding is the process of programming the receiver to recognize the GUID
(Globally Unique Identifi er) code of a single specifi c transmitter. The
STX2 ® transmitter and SPMSRX200 receiver are bound at the factory. If
you need to rebind, follow the instructions below.
1. With the vehicle on a fl at, level surface, insert the Bind Plug in the
BIND port on the receiver.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC. The red LED fl ashes, indicating the receiver is
in bind mode.
4. Center the ST TRIM and TH TRIM dials on the transmitter.
5. Turn the steering wheel to Full Right. Power the transmitter on
while holding the steering wheel to the Right.
6. Release the steering wheel when the receiver LED stops fl ashing.
7. Remove the Bind Plug, then power off the receiver to save the
settings.
8. Power off the transmitter.
9. Remove the bind plug and store it in a convenient place.
10. You must rebind when:
• Different failsafe positions are desired e.g., when throttle or
steering reversing has been changed.
• Binding the receiver to a different transmitter.

GETTING STARTED

1. Power on the transmitter.
3. Perform a test of the transmitter's control of the vehicle
with the vehicle's wheels off the ground.
2.4GHZ DIGITAL
RADIO SYSTEM
6

CHANGING THE THROTTLE LIMIT

Beginner Mode
Throttle Limiting Switch: 50%
• Best for learning the basic functions of left, right, stop, brake and
reverse
• For use in smaller areas
• Longest battery life
Best Overall Performance (Default)
Throttle Limiting Switch: 75%
• Great top speed and acceleration
• Easier to accelerate in desired direction, especially on loose surfaces
when compared to Maximum Speed setup
• Run time is greatly increased over Maximum Speed setup with
minimal impact to top speed
Maximum Speed
Throttle Limiting Switch: 100%
• More capable of popping and holding wheelies
• Higher top speeds and maximum acceleration
2. Power on the ESC.
4. Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
IMPORTANT: Seat the motor brushes by driving smoothly on a fl at
surface during use of the fi rst battery charge. Properly seating the motor
brushes will increase the life and performance of the motor.
AXE MONSTER TRUCK
™
Throttle Limit Switch