U‐Hub
The U‐Hub should never be exposed to rain or moisture during operation or storage. If the unit does come into contact with
moisture, remove the AC power cable immediately and leave it in a dry and warm location to dry out.
Note that when any equipment is taken from a cold location into a hot humid one, condensation may occur inside the device.
Always allow time for the equipment to attain the same temperature as its surrounding environment before connecting the AC
power cable.
IMPORTANT
It is the responsibility of the user to ensure that dirt, liquids and vapour from oil‐based theatrical smoke, haze or fog machines is
not ingested by the U‐Hub. Damage so caused is not covered by the manufacturer's warranty.
AC Power Connection
The U‐Hub utilises a standard IEC AC power connector fitted with a retaining clip. Use only an AC power cable with a correctly
wired IEC connector to make the connection to the mains power supply. This should be compatible with the retaining clip ensure
that the connector doesn't accidently disconnect.
The U‐Hub is designed to operate on 50/60 Hz AC power. The power supply section automatically configures for either 115V or
230V nominal voltage at turn on. The U‐Hub will operate over an extended range of supply voltages (please refer to the technical
specifications).
U‐Hub User Guide V1.0
USER GUIDE
8