Introduction And Key Features; Introduction; Key Features; U-Net Connections - Martin Audio U-Hub User Manual

U‐Hub
Introduction and Key Features
Introduction
The Martin Audio U‐Hub is an Ethernet to U‐NET bridge equipped with analogue and AES3 digital audio transport. It facilitates
PC connection and VU‐NET™ software control of MLA Series arrays and subwoofers via their inbuilt proprietary U‐NET network.
Key Features

Ethernet to U‐Net bridge

IP addressable (static and dynamic)

Analogue and digital audio transport

Designed to work with DX4.0 loudspeaker processor for Dante™ digital audio distribution
Converting TCP/IP to U‐NET protocol, U‐Hub allows MLA Series enclosures to self‐address and identify their position within an
array, as well as supporting a simple‐to‐use redundant loop. With U‐Hub, an MLA Series system with onboard U‐NET can be
seamlessly integrated into a TCP/IP network and controlled via VU‐NET software.
When used in conjunction with the Martin Audio DX4.0 networked system controller, U‐Hub can connect audio and network to
an MLA Series system with a single cable via a Dante™ digital audio network.
U‐Net Connections
The U‐Hub features two U‐Net ports and two pairs of parallel links to enable neatly loomed network cables to be used going to
and from several arrays. The U‐Net connections are available on 8‐pin ODU connectors. In common with standard Ethernet data,
U‐Net only uses four of the available 8 pins allowing balanced analogue or AES audio to be fed down two or the 'spare' cores
thus greatly simplifying system wiring as an independent audio cable is no longer required.
U‐Hub User Guide V1.0
USER GUIDE
10