Alarm Function - Silvercrest KH 2600 Operating Instructions Manual

Handling and operation

Alarm Function

When setting the wake time you confi gure the light intensity, the wake sound
and the volume. In the 30 minutes before the set wake time the light intensity
increases slowly to the selected level. When the set wake time is reached the
sound level increases, within 90 seconds, slowly to the selected volume.
Programming alarm wake times
The device has two alarms available. All settings for both alarms can be carried
out independently from each other. You can choose whether, at the programmed
time, an alarm tone or a variety of nature sounds should be played, whether
the radio should sound out or music from an iPod/iPhone or an external audio
device should be played.
Prerequisite: The device is in standby mode.
Press the ALARM1/DOWN button
ALARM2/UP button
AL1/AL2 button on the remote control. The hour
indicator in the display
Set with the ►►I button
the hour. With each button press the time changes
by one hour. Holding down the respective button
for more than two seconds starts the speed setting.
Press the ALARM1/DOWN button
ALARM2/UP button
AL1/AL2 button on the remote control. The
minute indicator in the display
Set with the ►►I button
13
changes by one minute. Holding down the re-
spective button for more than two seconds starts
the speed setting.
Press the ALARM1/DOWN button
device or the AL1/AL2 button on the remote control again to confi rm the
setting.
KH 2600
16
on the device or the
4
11
16
on the device or the
11
the minutes. With each button press the time
18
/
blinks.
13
or the I◄◄ button
18
/
4
blinks.
or the I◄◄ button
18
/ALARM2/UP button
GB
16
on the
21
IE