Maintenance; Maintenance After Operations; Lubrication - LELY SPLENDIMO T Operator's Manual

7 MAINTENANCE

Correct machine servicing is necessary with a view to
reliable and safe working.

Maintenance after operations

7.1
- Clean the machine thoroughly. After jet-cleaning allow for
a few moments rotation of the discs so that the water is
swept away.
- Check the mower knives and discs for tightness and
damage (see § 7.3).
- Check the safety cover for damage.
- Grease the machine with a rust preventive.
- Grease the piston rod with an anti-corrosion agent if a
longer period of inactivity is anticipated. Remove the agent
when putting the machine back into operation. If not,
sealing of the ram may be affected after hardening of the
anti-corrosion agent.

Lubrication

7.2
- PTO shaft to be greased every 8 working hours by the
grease nipples on the cross assemblies, protection tubes
and free wheel clutch (fig. 12).
- Profiled tubes of the PTO shaft to be greased every 8
working hours.
- Grease the PTO shaft above the drive element every 100
working hours in way of the grease nipples on the cross
assemblies. For this purpose, the cover A (fig. 13) and the
sealing plate B have to be dismounted. Remove soil and/or
crop material, if any, from the hat.
- Grease the pivots of the intermediate frame every 40
working hours.
- Grease or lubricate all remaining pivot points every 40
working hours.
- Apply a few drops of oil to the cams of the breakback
device every 40 working hours (fig. 14).
8 h
A
B
100 h
35
8 h
12
13