UNIVERSAL GAS VALVES VG SERIES SAFETY SOLENOID VALVES PRODUCT HANDBOOK APPLICATION These series manually operated safety solenoid valves are used in gas leak detection systems. CONTENTS General Description Features Model chart Technical Specifications Performance characteristics Capacity curves 7--8 Dimensional drawing 1000 series Dimensional drawing 3000 series Installation and operation Installation and final checkout...
DESCRIPTION The VG series safety solenoid valves The VG series safety solenoid valves The VG series safety solenoid valves offer the following functionality: cover a wide range of pipe size are available with 2 ” (DN 65) and Normally closed valve. Manual opening connections.
FEATURES Class ”A” manually operated safety The VGxxxxx series safety solenoid The VGxxxx series safety solenoid solenoid valves for use in gas leak valves may be assembled on the valves have coils turnable over detection systems. pipe line within 90 degrees of the The VGxxxxA series safety solenoid Cable strain relief can be achieved vertical axel.
SPECIFICATIONS Models Torsion and bending stress Enclosure The VG series consists of a series Pipe connections meet Group 2 IP 54 manually operated safety solenoid according EN 161 requirements. IP 65 on request valves from ” upto and including 3” Capacity Ambient temperature connection.
CAPACITY CURVE DN 50, DN 65, AND 80 (TREADED AND FLANGED CONNECTION) Capacity in m air at p = 2,5 mbar 2” DN 50 ” DN 65 3” DN 80 66,7 94,2 DN 80 DN 65 DN 50 Air d Natural gas (G 25) 40 50 60 80 100...
INSTALLATION AND FINAL CHECKOUT threads bare. PTFE tape may be Electrical connection Warning used as an alternative. Take care that installer is a trained Caution In order to tighten the pipe in the experienced service man. Switch off power supply before valve, do not use the actuator as a Turn off gas supply before starting making electrical connections.
CONSTRUCTION AND WORKING PRINCIPLES The VG series safety solenoid valves De--energization will cause the spring Valve closing spring is made out of are class A fail safe shutt--off valves. loaded closing member to close. steel according to AISI 302. The valve can be opened manually Seals and gaskets are manufactured A strainer made out of steel according after energizing the operator.
STANDARDS AND APPROVALS Standards The VG series safety solenoid valves The fact that the VG series safety The VG series safety solenoid valves also meet all Electro Magnetic solenoid valves are certified to have been designed to meet the Compatability standards for European Standard EN 161 means that European Standard EN 161.
ORDERING INFORMATION When ordering specify: Order numbers of replacement parts Note Model number of VG series safety and accessories required, i.e. Most models of valves, replacement solenoid valve required: see model flanges, compression fittings: see parts and accessories will be number chart below.
REPLACEMENT PARTS AND ACCESSORIES Warning Take care that only qualified persons carry out the installation of parts, accessories, and add on components. Follow the installation instructions included in the package. Check that the selected part, accessory or add on component is the correct one for the application in question. Specifation of data is given in the instruction leaflet in the package.
Page 16
REPLACEMENT OF COIL Remove setting knob (1) Unscrew cap (2) with suitable wrench and remove it from the coil assy Remove cap of connection box Disconnect coil from rectifier board by releasing both wires from connector (5) Remove coil from exteria pipe (4) Place new coil in exteria pipe (4) Connect both wires to connector on rectifier board (5)