Installation - dji Pro Wireless Receiver User Manual

regions are not supported 5.8GHz, make sure the switch is toggled to the 2.4GHz.
3. Link Button
Press and hold this button for two seconds to start linking to the controller.
4. Status LED
Indicates the status of system.
5. Power and Communication Port
Connect this port to gimbal using the CAN Bus cable, D-Bus and S-Bus cable.
6. S-Bus/CAN Switch
Toggle the switch to CAN position when using with Ronin 2 and Ronin-S, toggle the switch to S-
Bus position when using with an S-Bus gimbal.
7. USB-C Port
For activation and firmware updating.
8. 1/4"-20 Mounting Hole
For fixing the receiver in place.
9. M4 Mounting Hole
For fixing the receiver in place.

Installation

It is recommended to fix the wireless receiver at a place that without signal interference through
the mounting hole on the receiver or using other tools.
Cable Connections
1. Connect to Ronin 2: connect the Power and Communication Port to the Ronin 2 accessory
power ports above the pan motor using the CAN Bus cable.
2. Connect to Ronin-S: connect the Power and Communication Port to the Ronin-S' CAN port
using a CAN cable (sold separately)
3. Connect to an S-Bus supported gimbal connect the Power and Communication Port to the
gimbal's S-Bus port.
Keep the Antennas vertical during using, and make sure there is no obstructions and interference
between the devices.