Table of Contents
Advertisement
18 (30)
8.
Lift off the loosened metallic cover. The Beryllium Oxide component is
now visible. Cut the seven pins and the small metallic tongue as per Figure
13.
Figure 13 Locating the seven pins and the small metallic tongue to be cut off.
9.
Remove the loosened Beryllium Oxide component by lifting it off as per
Figure 14.
Figure 14 Removing the Beryllium Oxide component from the board.
The component containing Beryllium Oxide is now removed. Steps 10 to 13
refer to BRU3 900 MHz only.
BRU3 MANUAL
ROA 117 2015/2
R2G
A400004R79 95W08
A40
ROA 117 2015/2
R2G
A400004R79 95W08
A40
BRU3 MANUAL, Doc.no: b3saf_en Uen Rev PH1, 2003-10-20
Advertisement
Table of Contents
