Table of Contents
Advertisement
5.
Locate the FE Radio Board, see Figure 11.
Figure 11
Locating the FE Radio Board in the FE Case Bottom Frame (FBF).
The FE Radio Board is to the right in the figure.
6.
Make sure that the FE Radio Board is undamaged. Do not work with the
BRU3 if the FE Radio Board looks burned or damaged in any way. If this
is the case close the BRU3 and treat the BRU3 as beryllium oxide
hazardous waste.
.Note!
For a BRU3 used for 900 MHz proceed to step 10. For a BRU3
used for 400 MHz continue with the following steps.
7.
Unscrew the two screws as per Figure 12.
Figure 12 Removing two screws.
BRU3 MANUAL, Doc.no: b3saf_en Uen Rev PH1, 2003-10-20
SAFETY INSTRUCTIONS
ROA 117 2015/2
A400004R79 95W08
R2G
A40
17 (30)
Advertisement
Table of Contents
