Unfolding & Adjusting Lower Handle; Installing Cup Holder; Installing The Grass Catcher Bag; Installing/Removing The Mulching Plug - Bushranger BRU36v9601 Operator's Manual

ASSEMBLY
Unfolding and Adjusting Lower Handle
WARNING
• Folding or unfolding the handle improperly can damage the cables, causing an
unsafe operating condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an authorized Bushranger
Install Cup Holder (Fig. 1)
• Open attachment bag find 4 PCS M4x15 screw and find the cup holder (P) in packing box.
• Install cup holder (P) to upper handle assembly and lock screw.
Unfolding and Adjusting Handle Assembly
To raise handle assembly:
• Pull up and back on the lower handle (1) until it is aligned with the hole position of
the arm support and the mower housing.
• To secure the lower handle (1) in place, lock the lower screw (3).
• Open the upper cam locks (2).
• Pull up and back on the upper handle to raise it into operating position.
• To secure the upper handle in place, close the upper cam locks (2).
NOTE: If the upper handle is loose or separated from the lower handle, tighten the
knobs on the upper handle locks by turning them clockwise.
Installing The Grass Catcher
• Make sure all rotating parts have come to a stop.
• Lift the rear discharge door (1).
• Lift the grass catcher by its handle (2) and place under the rear discharge
door so that the hooks (3) on the grass catcher are seated on the door rod (4).
• Release the rear discharge door. When installed correctly, the hooks on the grass
catcher will extend through the openings on the rear discharge door.
NOTE: When using the grass catcher, do not install either the side discharge deflector
or the mulching plug.

Installing/Removing The Mulching Plug

• Make sure all rotating parts have come to a stop.
• To remove the mulching plug, lift the rear discharge door (1).
• Grasp the handle (2) of the mulching plug.
• Lift and pull the mulching plug out using the handle.
INSTALL CUP HOLDER (1)
1. Install cup holder :
• Open attachment bag find 4 PCS M4x15 screw
and find the cup holder (P) in packing box.
14
• Install cup hodler (P) to upper handle assembly
14
and lock screw.
UNFOLDING AND ADJUSTING LOWER HANDLE
UNFOLDING AND ADJUSTING LOWER HANDLE
WARNING
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an
Folding or unfolding the handle improperly can damage the cables, causing an
unsafe operating condition.
unsafe operating condition.
• Do not damage the cables when folding or unfolding the handle.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
• If a cable is damaged, contact an Authorized Service Dealer.
Service Dealer.
®
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
a. To raise handle assembly:
a. To raise handle assembly:
• Pull up and back on the lower handle (1) until it is
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY (2)
• Pull up and back on the lower handle (1) until it is
aligned with the hole position of the arm support
and the mower housing. aligned with the hole position of the arm support
• To secure the lower handle (1) in place, lock the and the mower housing.
a. To raise handle assembly:
• lower screw (3). To secure the lower handle (1) in place, lock the
• Pull up and back on the lower handle (F) until
• Open the upper cam locks (2). lower screw (3).
it is aligned with the hole position of the arm
• • Pull up and back on the upper handle to raise it Open the upper cam locks (2).
support and the mower housing.
• into operating position. Pull up and back on the upper handle to raise it
• To secure the lower handle (F) in place, lock
• To secure the upper handle in place, close the into operating position.
the lower screw (M).
• upper cam locks (2). To secure the upper handle in place, close the
• Open the upper cam locks (H).
upper cam locks (2).
• Pull up and back on the upper handle to raise
NOTE: If the upper handle is loose or separated from
it into operating position.
NOTE: If the upper handle is loose or separated from
the lower handle, tighten the knobs on the upper
• To secure the upper handle in place, close the
the lower handle, tighten the knobs on the upper
handle locks by turning them clockwise.
upper cam locks (H).
handle locks by turning them clockwise.
NOTE: If the upper handle is loose or separated
from the lower handle, tighten the knobs on the
upper handle locks by turning them clockwise.

INSTALLING THE GRASS CATCHER BAG

INSTALLING THE GRASS CATCHER BAG
• Lift the rear disc harge door (1).
• Lift the rear disc harge door (1).
• Lift the grass catc her by its handle (2) and
• Lift the grass catc her by its handle (2) and
place under the rear disc harge door so
place under the rear disc harge door so
that the hooks (3) on the grass catc her are
that the hooks (3) on the grass catc her are
seated on the door rod (4).
• Release the rear disc harge door. When seated on the door rod (4).
• installed correctly, the hooks on the grass Release the rear disc harge door. When
catcher will extend through the openings on installed correctly, the hooks on the grass
the rear disc harge door. catcher will extend through the openings on
the rear disc harge door.
NOTE: When using the grass catcher, do not
install either the side discharge deflector or the NOTE: When using the grass catcher, do not
mulching plug. install either the side discharge deflector or the
mulching plug.
INSTALLING/REMOVING THE MULCHING PLUG
• To remove the mulching plug, lift the rear
discharge door (1).
• Grasp the handle (2) of the mulching plug.
Lift and pull the mulching plug out using the
handle.
• The mulching plug (3) is in serted at an angle,
so it requ ires some force to remove it.
• The mulching plug must be removed in order
to inst all the grass catc her bag.
• The mulching plug must be re-inst alled when
the grass catc her bag is removed.
NOTE: When mulching, do not install either the
side discharge deflector or the grass catcher bag.
INSTALLING SIDE DISCHARGE CHUTE
• Lift the side discharge cover (1).
1
P
1a
2a
1
H
1
1
1
1
1
2
2
2
3
3
3
1
1
2
2
3
3
2
F
3
3
3
M
15
4
4
EN
4
11