Table of Contents
Advertisement
®
NitraLyt
NOA; NitraLyt
Installing the
®
NitraLyt
NOA/AT
®
in the NitraLyt
reference electrode
ba75408e04
12/2005
®
NOA/AT
Assembly
NOA
5
1
Remove the wet cap (5) and blind plug (6) from the reference
electrode. Store both accessories. You need them if you want
to store the reference electrode.
7
2
Remove the watering cap (7) and nut (8) from the exchange
electrode.
Store both accessories. You need them if you want to store the
reference electrode.
3
Screw the NitraLyt
NitraLyt
A flat wrench (wrench size 13 mm) or the protective hood of the
sensor is suitable as a wrench (see following figure).
6
8
®
NOA/AT exchange electrode into the
®
NOA reference electrode without leaving any gap.
Protection hood
Assembly
15
Advertisement
Table of Contents
