Putting Into Operation - elobau 471 M41 H31 Translation Of The Original Operating Instructions

5

Putting into operation

Danger of electrocution!

Ensure that the control unit is only installed and put into opera-
tion by specially-trained authorised personnel.
Danger
- Remove the top cover of the control unit.
- Set the switches.
- Ensure that both rows of switches are set identically.
- Close the top cover of the control unit.
- Ensure that all sensors are energized.
- Apply operating voltage.
With the operating voltage applied:
The operating voltage LED is on.
LEDs 3, 4 and 5 are flashing.
The control unit will perform an internal self-test.
After successful completion of the test:
The control unit switches through the safety output and the control output.
The operational standby LED is lit.
The control unit is ready for operation.
900565 / 04.04.2016
GB
25