Table of Contents
Advertisement
SETTING OF THE CAMERA
3
Press the
Display.
4
Use the
buttons to select the Remote
Control Mode and press the
the
buttons.
5
Use the
button to select the same channel as the remote controller (In the
case of the RS-11, please select C1) and then press the
buttons. (After setting the channel, the
6
Check that the subject is framed correctly. After you set the focus, we
recommend setting the lens switch to MF position.
7
Point the transmitting diode at the camera and press the transmit button.
8
After taking the picture, please cancel the Remote Control Mode following the
above procedure from number 3 to 4, and then choose OFF mark to cancel
remote control function.
The Remote Control Mode cannot be used together with continuous shooting
■
mode. If the "D"-dial is set to the continuous shooting mode, the camera will
expose only one frame for each activation by the remote controller.
The remote controller may not work properly if strong sunlight is shining directly
■
on the camera's remote control sensor.
The light entering the viewfinder can affect the exposure system of the camera. To
■
prevent this, use the finder cap while using the remote controller.
WARNING !!
•
When the Remote Control Mode is set to ON, Auto Power Off will not
function. If you are not using Remote Control please cancel the remote
control mode by choosing OFF.
button to show the Function
button or
mark will be displayed.)
button or the
76
Advertisement
Table of Contents
