Table of Contents
Advertisement
WARNING!!
•
After cleaning the image sensor, please ensure the dust protector is correctly
attached. If the dust protector is not properly attached, it may move and
damage the image sensor of the camera or the lens.
•
Please do not use the blower with the brush for cleaning the image sensor.
If the bruch is attached, it may scratch the image sensor of the camera.
•
We recommend using the AC adapter (sold separately) to clean the image
sensor. If the AC adapter is not used, please be sure to fully charge the
battery. If the battery voltage is less than the normal level, the camera will
warn you with an electronic "beep". In such cases, stop the cleaning process
immediately and fully charge the battery. Failure to do so can result in
damage.
111
1
Turn the "D"–Dial to the
remove the lens.
2
To detach the dust protector, slide it upwards
from its projecting lip with your fingernail. Be
careful not to touch the glass on the dust
protector.
3
Once the dust protector slides upwards, the
lower part of the dust protector is released.
Grasp it and remove the dust protector. (Be
careful not to touch the glass on the dust
protector.)
position and
Advertisement
Table of Contents
