Husqvarna 520iLX Operator's Manual page 20

4. Start the product, see
26 .
5. Apply full throttle.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
To do a check of the power trigger lockout
The power trigger lockout is designed to prevent
accidental operation. When you push the power trigger
lockout forward (A) and then press the power trigger
lockout against the handle (B), the power trigger (C) is
released. When you release the handle, the power
trigger and the power trigger lockout both move back to
their original positions. This movement is operated by
three independent springs.
C
1. Make sure that the power trigger is locked when the
lock is in its original position.
2. Push the power trigger lockout forward (A) and
down. Hold the power trigger lockout against the
handle (B) and make sure that it returns to its
original position when you release it.
20
To start the product on page
B
A
B
A
3. Make sure that the power trigger and the power
trigger lockout moves freely and that the return
springs operate properly.
4. Start the product, refer to
page 26 .
5. Push the power trigger fully to apply full speed.
6. Release the power trigger and make sure that the
cutting attachment stops and remains still.
To do a check of the cutting attachment guard
WARNING: Do not use a
cutting attachment
without an approved and
correctly attached cutting
attachment guard.
Always use the
recommended cutting
attachment guard for the
cutting attachment that
you use, see
Accessories on page
34 . If an incorrect or
faulty cutting attachment
guard is attached this
can cause serious
personal injury.
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the motor.
To start the product on
756 - 001 - 24.10.2018