Table of Contents
Advertisement
Chapter 4
Operations of the keys on the LCD display
4.1 Display of Comat BoxX status
Connect the power line of Comat BoxX with the method as described in Chapter II.
After power is on, LCD displays a frame, which is the Switch-on Frame.
As shown in Fig. of Comat BoxX. 4.2 (10 points type):
The upper line I contains the status values of inputs I1 – I6 respectively I1 – I12. The lower line Q
contains the status values of outputs Q1 – Q4 respectively
Q1 – Q8. (In which „*" indicates ON, i.e. status „1" [] indicates OFF status, i.e. „O".
4.2 Confirm password
Pressing
and
simultaneously at the Status Display Frame as shown in Fig. 4.2, the user can
enter into the Confirm Password Frame, as shown in Fig. 4.3.
It is required by Comat BoxX to input the password value before the access is permitted. (Password
must contain 4 digits).
The cursor stays at a high digit of the password, where you can change the digit value (0-9)
with
and
keys (when you initially press
Then by using
and
of the remaining digits. If a proper password is selected, it will enter the Edition Frame shown in Fig.
4.4. If the password is incorrect, consecutively three times, the Status Display Frame as shown in Fig.
4.2 will reappear.
Note:
The Ex-works password is «0001».
Fig. 4.2 Status Display Frame
keys to change the password input position and input the password values
Fig. 4.3
or
keys, the password value is 0).
Comat BoxX, Hardware User's Manual / 11.2004 E
23
Hide quick links:
Advertisement
Table of Contents
