Connecting Of Comat Boxx Output - Comat BoxX Series Hardware User Manual

Chapter 2
Installation and wiring of Comat BoxX

2.2.3 Connecting of Comat BoxX output

The AF-10MR-A, AF-10MR-D, AF-20MR-A, AF-20MR-D, all have relay outputs.
The AF-10-MT-GD (PNP), AF-20-MT-GD (PNP) are transistor output types. It is necessary to have a
separate power supply for the load. The power supplies must have the same potential.
1. Requirement for the relay output
Various loads such as lamps, fluorescent tubes, motors, contactors, etc., can be connected to the
outputs of Comat BoxX. The max. ON output current that can be supplied by the Comat BoxX
controller is 8A for resistive load.
Compare datasheet in Chapter III.
The connection is shown as follows:
2. Requirements for the electronic transistor output
The maximum switch current should not exceed 2A; when the switch is ON (Q=1).
Compare datasheet in Chapter III.
The connection is as the shown below:
Note:
Output Q must be on the same potential as input I.
Fig. 2.9 Relay output
Fig. 2.10 Transistor output
Comat BoxX, Hardware User's Manual / 11.2004 E
15