Email Directory - Siemens GigasetS44 Owner's Manual

Siemens owner's manual telephone gigasets44
Table of Contents

Advertisement

Using the directory and lists
Voice dialling
You can dial numbers from the directory
by saying the name. To enable your phone
to recognise your voice, you have to
record a voice pattern for every name,
i.e.say the name loudly to the handset and
store it.
You can also set your telephone to
announce the name of the caller instead
of ringing for an external call, see
page 21.
You can store a voice pattern for a total of
30 directory entries. Entries assigned
voice patterns are marked with ´.
Recording voice patterns
Record your voice pattern in quiet sur-
roundings. The handset should be around
25 cm (10 inches) away from you. The
voice pattern can be 1.5 seconds long.
Note:
If you use voice dialling usually with a hands-
free set, then it is advisable to record the voice
pattern via the handsfree set.
¢
s
s (Select entry; page 12)
v
Open menu.
Record Pattern
Select.
Press the display key to start
§OK§
the recording.
You will hear a short beep. The display will
prompt you accordingly. Speak the name.
Repeat the name after being prompted to
do so by the display and a further beep.
Note:
If the phone's memory cannot accommodate a
new voice pattern, a message will appear on
the display. The handset will automatically
return to the directory. Delete a voice pattern
and select
Record Pattern
To change a voice pattern, you must
delete it (page 14) and re-record it.
14
once again.
Using voice dialling
t
Press and hold.
Speak the name after the beep. If the
name corresponds with the recorded
voice pattern, it will be repeated and the
number will be dialled.
Playing voice patterns
¢
s
s (Select entry with ´ )
v
Open menu.
Play Pattern
Select and press
pattern will be played in
handsfree mode.
a
Press and hold (idle status).
Deleting voice patterns
¢
s
s (Select entry with ´)
v
Open menu.
Delete Pattern
Select and press
a
Press and hold (idle status).
The directory entry is retained.

Email directory

You can store email addresses in the email
directory.
Saving a new email address
s
Open the directory.
<E-Mail Directory>
Select and press
Select and press
New Entry
~
Enter email address
(max. 60 characters).
¤
Save changes (page 10).
During entry, you can open the menu with
©
and use the following functions:
/
Insert '.'
Insert '@'
Insert a dot or @.
. The voice
§OK§
.
§OK§
.
§OK§
.
§OK§

Advertisement

Table of Contents
loading

Table of Contents