Table of Contents
Advertisement
Using a handset as a room monitor
Using a handset as
a room monitor
If the room monitor is activated, a previ-
ously stored destination number is called
as soon as soon as a set noise level is
reached. You can store an internal or
external number on your handset as the
destination number.
The room monitor call to an external
number stops after approx. 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
While the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringtone and are only
shown on the screen. The display and keys
are not illuminated and advisory tones are
also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, the function remains acti-
vated.
If you switch off the handset, the room
monitor mode is ended. You must reacti-
vate the function after switching on the
handset again.
16
Note:
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection, if you are diverting the room
monitor to an outside number.
– The active room monitor function consider-
ably reduces the operating time of the
handset. Place the handset in the charging
cradle if necessary. This ensures that the
battery does not discharge.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answering machine.
Activating the room monitor and
entering the number to be called
¢
¢
v
í
Room Monitor
¤
Changing multiple line input:
Room M.:
Select
On
to activate.
Call to:
Press the display key
tination number.
External number: select number from
the directory or enter directly. Only the
last 4 digits are displayed.
Internal number:
on the base station either s (select
handset) or ~ (enter number of hand-
set) and
. If all handsets registered
§OK§
on the base station should be called,
select
Call
All.
Store number with
Level:
Set sensitivity for the noise level
High).
¤
Save changes (page 10).
The function is now activated. With v,
you can change directly to settings.
and enter des-
§Edit§
and depending
§INT§
© Save Entry
.
§OK§
(Low
or
Advertisement
Table of Contents
