Appendix; Care; Contact With Liquid; Questions And Answers - Siemens GigasetS44 Owner's Manual

Appendix

Function
EATONI
predictive text
Alarm clock/appoint-
ment
Character set
Appendix

Care

¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
26
Default Page
setting
on page 30
off page 23
standard page 30
!

Questions and answers

If you have any queries about the use of
your handset, you can contact us at any
time at www.siemens.com/gigasetcus-
tomercare. The table below contains a list
of common problems and possible solu-
tions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The batteries are flat.
¥
Charge or replace the batteries (page 4).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
"Base station x" flashes in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 5).
Base Search flashes in the display.
Handset is set for
Best Base
is within range.
¥
Reduce the distance between handset/base
station.
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 21).
The other party cannot hear you.
You have pressed the
set is "muted".
¥
Switch on the microphone again (page 11).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.
a
.
#
(page 6).
and no base station
u
(INT) key. The hand-